simpleolz.blogg.se

Exit the networkParams sub-menu and return to the host service menu. Once all of the IP addresses or IP address ranges have been entered into the access-list, use the show settings command to verify them.This is shown in Figure 5.6.ħ. Using the accessList command, enter the IP address and netmask of the hosts or subnets that will be allowed access to the IDS sensor through the network interface.The format of this command is: accessList ipAddress. Select the network parameters sub-menu using the networkParams command.ĥ. Enter the host service sub-menu using the service host command.Ĥ. Enter configuration mode using the configure terminal command at the CLI prompt.ģ. Log in to the sensor using the cisco account.Ģ. Once the sensor has finished rebooting, the next step is to configure the allowed hosts which can connect to the SSH server on the sensor.This can be accomplished as follows:ġ. Warning: The node must be rebooted for the changes to go into effect. laws governing Cisco cryptographic products may be found at: and local laws, return this product immediately.Ī summary of U.S. Importers, exporters, distributors, and users are responsible for their compliance with U.S. Delivery of Cisco cryptographic products does not imply third-party authority to import, export, distribute or use encryption. This product contains cryptographic features and is subject to United States and local country laws governing import, export, transfer, and use.

Last login: Thu Sept 25 15:58:25 on ttyS0